Installing a new AC without checking line set length, refrigerant match, and cooling load is how Van Meter homeowners end up with a unit that never performs to spec. Every quote includes a real cooling load assessment before equipment is selected.
New AC installs miss their rated SEER2 efficiency more often than people realize, usually from oversizing or a mismatched line set. Equipment gets sized to the actual cooling load, and line sets follow manufacturer spec, not the shortest path.
The details other installers skip.
We calculate before we recommend.
A range of efficiency tiers lets you weigh upfront cost against long-term savings to fit different budgets.
You get a written labor warranty on top of manufacturer coverage.
Line sets follow manufacturer specification, not the shortest physical route, since a bad run quietly kills efficiency.
From load calculation to startup commissioning.
A full assessment determines actual cooling demand, not a generic estimate.
SEER2 ratings get explained in plain terms so the decision is based on real numbers, not marketing language.
Line sets are sized and insulated to manufacturer spec, avoiding efficiency losses from a poor run.
Placement is planned, not just wherever's convenient.
We test before calling it done, not just assumed correct.
Removal and disposal follow EPA rules.
Four steps from assessment to cold air.
An on-site visit gets scheduled, since accurate sizing can't be done by phone.
A tech shows up with assessment equipment and evaluates the home for a direct evaluation.
The quote includes several SEER2 efficiency tiers based on your actual load numbers.
We install, verify performance, and back the work in writing.
Recent reviews from new system installs.
Compared quotes from four companies before deciding. This was the only one that showed me actual Manual J numbers instead of a flat price sheet.
— T. Longworth, homeowner
We wanted the quietest unit available since our bedroom windows face the side yard where it sits. They steered us toward a model rated specifically for noise.
— I. Adeyinka, homeowner
Had a mini-split installed in a converted garage that never had ductwork. Clean install, didn't have to cut into any walls we cared about.
— C. Bergstrom, homeowner
Installed new rooftop units at two of our retail locations within the same week. Consistent process and pricing at both sites.
— N. Falkirk, retail operations manager
Common questions before a Ac Installation project.
A proper on-site calculation is the only reliable way to size correctly.
Whether it pays off depends on a few factors we cover at quote time.
A typical install wraps up in one day, longer for complex line runs.
Handled on our end, to EPA standard.
Both system types are covered, chosen based on the property.
If something about how the unit was put in causes a problem down the line, that's on us to fix at no charge, on top of whatever the manufacturer covers on the equipment itself.
Our coverage spans Van Meter and nearby zips shown here — call to schedule.
Schedule My Assessment
